Skip to main content
JGB Stump Grinding

Houston, TX · Stump grinding only · Solo operator

Stumps gone. Ground flush. Yard back.

Houston-area stump grinding only — no mowing, no tree felling, just the one thing done right. Solo operator, fair on-site quote, most yards back in shape the same morning.

Free, no-pressure walk-through. We quote on-site so the number you get is the number you pay.

Stump grinding only — that’s all we do Houston metro · solo operator Fits 36-inch gates Insured · on-site quote

What we do

One trade,done right

Stump grinding only. From a single crepe-myrtle stump out front to a hedge-row of pecans after a removal — quoted on-site, ground below grade, chips left as mulch or hauled off.

Small Stump Grinding

Stumps under 12 inches across — most front-yard ornamentals, crepe myrtles, ligustrums. In and out in an hour.

starts at $125 · per visit

Medium Stump Grinding

12–24 inch stumps — pines, oaks, magnolias. Most of what comes out of a Houston back yard.

starts at $195 · per visit

Large Stump Grinding

Big oaks, water oaks, pecans, hackberries — anything over 24 inches across. Bring the bigger machine.

starts at $325 · per visit

Multi-Stump Discount

3+ stumps in one visit get a per-stump discount. Lot clearings, hedge-row removals, fence-line cleanups.

starts at $95 · per visit

Surface Grind (Above-Grade Only)

When you just need the visible stump gone — no replanting planned. Cheaper than a full below-grade grind.

starts at $85 · per visit

Below-Grade Grinding

Standard depth — 4 to 8 inches under grade so the area is plantable, soddable, irrigation-safe.

quoted on-site

Stump + Chip Cleanup

Most quotes leave the chips in the hole as backfill. If you want them hauled off, we do that too.

starts at $65 · per visit

Surface-Root Tracing

Those tripping-hazard roots running across the lawn? We chase them out with the grinder.

starts at $110 · per visit

How stump grinding actually works

Below grade, not just flush.

Most stump complaints come from a surface grind — the visible part is gone but the roots are still right under the lawn. Below-grade is the difference between a yard you can sod and a yard that lumps back up after the next rain.

  • Standard depth: 4–8 inches below grade. Enough for sod, topsoil, or shallow irrigation lines.
  • Buttress roots traced 1–2 ft out. Big oaks, pecans, and water oaks throw thick roots — they need to come down too or they lift the lawn.
  • Chips backfill the hole. They settle ~25% in a season — top with topsoil after, then sod or seed.
Cross-section of a residential stump grindSide view showing a tree stump ground 6 inches below grade, the surrounding root system, the resulting chip-filled hole, and the topsoil + sod layer that goes on after the work is finished.BEFOREgrade~6 inbelowAFTERold root systemroots ground outchips backfillnew sod / topsoilJGBHOUSTON · TX
Cross-section, not to scale. Actual stumps vary — call with the diameter and we’ll tell you what depth fits the job.

How it works

Three steps,no hassle

One trade, one truck, one machine — and a plant-able patch of dirt where a stump used to be.

  1. Send the photo

    Phone photo of the stump and the gate, plus the address. That gets you a same-day ballpark and a slot on the schedule.

  2. On-site quote

    Most jobs get a firm quote when I arrive — measured at ground level. The number on the spot is the number on the invoice.

  3. Ground out, cleaned up

    Below-grade grind, surface roots traced, chips backfilled (or hauled — your call), walkways blown clean before I leave.

Hand-drawn diagram: stump grinder fitting through a 36-inch back-yard gate36 inchesJGBinto the back yard

Practical specs

Yes, it fits through your gate.

The most common reason a stump never gets ground is that the homeowner assumes the machine is too big. It usually isn’t.

Small machine
Fits a 36-inch gate. Gets through almost any side yard. Handles stumps up to 24″.
Larger machine
Needs about 48 inches. Reserved for big oaks and pecans where the small one would take all day.
Tight side yards
Hard turns and AC condensers count. Send a phone photo before the visit and I’ll tell you on the spot whether we’re good.
No gate at all?
Common with corner lots and full fences. Most fence boards come off and back on without damage — no charge for the ten minutes.

Bottom line: if you can roll a wheelbarrow back there, the small machine almost certainly fits. Send a photo if you’re unsure — saves a wasted truck-roll.

In their words

What customers say

A few Houston-area homeowners who had a stump in the way of something — sod, a fence, a new tree, a smooth lawn.

Joel showed up on time, fit the grinder through a 36-inch gate I was sure was too narrow, ground a big water oak stump to dust, and was gone in two hours. The chips made nice mulch for the bed.

Kim S.

via Google

Had four old crepe myrtle stumps the previous tree guy left. Joel knocked all four out in one visit and gave me a multi-stump rate. Yard is finally smooth enough to mow without dodging.

Marcus T.

via Google

After Hurricane season we had a snapped pecan that the tree crew left as a 30-inch stump. Joel came out, looked at it, gave me a fair number on the spot, and ground it well below grade so I could sod over the area in spring.

Pat R.

via Yelp

Got a stump that needs to be gone?

Call with the address and a phone photo of the stump and the gate. Most quotes happen on the spot — and most jobs land within the week.

Get a quote

Tell me about the stump.

Diameter at ground level, gate width if it’s in the back yard, and a phone photo if you’ve got one. That’s usually enough to give a number same-day.

  • We typically reply same-day during the week.
  • No marketing emails — only what you asked about.
  • Free walk-through and on-site quote.

By submitting, you agree to our Privacy Policy and Terms. By providing a phone number, you consent to receive calls or texts from JGB Stump Grinding about your inquiry. Message and data rates may apply. Reply STOP to opt out.

Good to know

Frequently asked

  • Standard is 4 to 8 inches below grade — deep enough to sod, plant, or run shallow irrigation. If you are putting in a deeper line or a tree right back where the old one was, tell us and we will go deeper in that spot.